Irradiation-Crosslinkable TPU Elastomer Insulation Compound

Irradiation-Crosslinkable TPU Elastomer Insulation Compound

Irradiation-Crosslinkable TPU Elastomer Insulation Compound is a high-performance cable insulation material modified by electron beam irradiation crosslinking. It is based on TPU and retains the convenience of thermoplastic processing while forming a three-dimensional cross-linked network through irradiation, obtaining the heat resistance and mechanical stability of thermosetting rubber like materials. It is suitable for power cords, electric vehicle cables, wind energy cables, etc.

Irradiation-Crosslinkable TPU Elastomer Insulation Compound List

Model	Unit	TPU-19E
Item	/	Typical
Density	g/cm3	1.20
Tensile Strength	MPa	37
Elongation at Break	%	490
Air Oven Aging	℃×h	121×240
Tensile Strength Change Rate	%	+2
Elongation at Break Change Rate	%	-9
Breakdown Voltage	kV/mm	22
Tear Strength	N/mm	24.0
Low-temperature Performance Test	℃	-40
Oxygen Index	%	/
Volume Resistivity	Ω·cm	8.3×1013
Compression Set (70℃x22 h)	%	50
Halogen Acid Gas Content	mg/g	0
pH Value	/	5.8
Conductivity	μs/mm	1.0
Fluorine Content	%	0
Environmental Protection Requirements	Level	Conforms to EU RoHS Directive (2011/65/EU) and REACH Regulation (EC 1907/2006) Substances of Very High Concern (SVHC) provisions.

Irradiation-Crosslinkable TPU Elastomer Insulation Compound Application

Irradiation-Crosslinkable TPU Elastomer Insulation Compound is a high-performance cable insulation material modified by electron beam irradiation crosslinking. It is suitable for power cords, electric vehicle cables, wind energy cables, etc.